Myblend GO Instructions
Smooth Blending
Smooth Blending
To make your blending experience as smooth as possible with Myblend, we recommend that you put in your fluids first. This will allow the blades to work efficiently without getting jammed by any ingredients.
Smaller Pieces
Smaller Pieces
We recommend that you cut your fruits / ingredients to smaller pieces before blending.
Easy Blend
Easy Blend
As recommended, put in your fluid of choice. Proceed to add the remaining ingredients and blend until smooth!
Frozen Fruit / Ice
Frozen Fruit / Ice
If you are blending a lot of ingredients / frozen ingredients or ice - start the blender upside down. Make sure the blades are completely free. Slowly flip the blender back up again so that all ingredients hit the blades in full speed.
Safety Precautions
Safety Precautions
Avoid at all times to put your hand inside of the blender. If the blender is being used by a child it should always be done by adult supervision.
Don’t Run Empty
Don’t Run Empty
Don’t run your Myblend empty, doing so might damage the motor.
Cleans Like A Dream
Cleans Like A Dream
Myblend cleans itself! Just fill about half of the blender with water and a little bit of soap. Blend, and then rinse with cold water.
Warm Fluids
Warm Fluids
Do not blend fluids that are warmer than 115° F / 45 ° C in your Myblend, since this could cause damages to the container and leakages to the base.
Jammed Blades
Jammed Blades
If you experience that the blender doesn't start when you have a lot of ingredients in it, it's because something is blocking the blades. To resolve this, flip the blender over and shake it until all the ingredients are separated from the blades. Turn the blender on and slowly flip it back up again, so that all ingredients hit the blades in full speed.
Not Aligned (Blinking Lights)
Not Aligned (Blinking Lights)
If the lights are switching between red & blue, it's a sign that the built in magnets in the container and base are not aligned. They need to be aligned for the blender to start. To resolve this issue, simply tighten the container a bit against the base. (The little arrow should point down to the start button)
Drying
Drying
After you have cleaned your Myblend, detach the lid and the container from the base. Let every part air dry separately before mounting them back together. This will help keep your Myblend nice and clean and will prevent odors from getting stuck in the blender.